EOS EMOTEC B6000 Podręcznik Użytkownika Pobierz pdf (Strona 7)

7GB

Connect the shielding to mass in the control

unit. This is the left contact on the

corresponding sensor connector terminals.

Please note that the following

measurements are based on values

provided by the unit quality assurance by the

European Standard EN 60335-2-53. In

principle, you must mount the oven sensor

where temperatures are expected to be the

highest. Illust. 6 gives you an overview of the

mounting point of the sensor.

Connecting the sauna lamp

The sauna lamp must be splashproof (by

Standard IPx4) and resistant to ambient

temperature. The sauna lamp can be

mounted anywhere except in the area of

the rising hot air above the oven.

Connecting the sensor lines

You should not install sensor and power

supply lines together, or lead them through

the same conduit. This can lead to

interferences in the electronics, such as

"fluttering" in the relays. If it is absolutely

necessary to install them together, or the

wire is longer than 3m, you should use a

shielded sensor line such as the LIYLY-O x

0.5 mm²).

Illust. 8Illust. 7

20 cm

Illust. 6

Mounting the oven sensor

1. Mount the oven sensor in cabins up to

2 x 2m according to Illust. 6 and 7, in larger

cabins according to Illust. 6 and 8.

19 cm

35 cm

Hole

Sensor housing

Sauna ceiling

Center sensor

housing on middle

section

Sensor line

Terminals in

the control unit

Illust. 9

2. Drill a hole to lead the cable through,

preferably through the middle of one of

the wooden boards.

3. Lead the sensor cable through the

drilled hole and attach it to the sensor

line according to Illust. 9.

Limiter Sensor

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Komentarze do niniejszej Instrukcji

Brak uwag